Logo

B0752 Engine Code Repair

Meaning of B0752 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B0752 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B0752 code is occuring now you should check B0752 repair processes.
Now don't ask yourself; What should you do with B0752 code ?
The solution is here :

B0752 Possible Solution:

B0752 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

B0752 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

7
Fuel Temperature Sensor B Circuit Range/Performance

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

2
Crankshaft Position Sensor A Circuit Low Input

Regarding the B0752 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B0752 OBD-II Diagnostic Body (B) Trouble Code Description

B0752 engine trouble code is about Crankshaft Position Sensor A Circuit Low Input.

Main reason For B0752 Code

The reason of B0752 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

Parts or components should not be replaced with reference to only a B0752 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.